
Job Menu
15
Radio Communications Screen
-or-
The Radio Communications screen is used to change the settings for
communication between the base or rover receiver and the radio.
Baudrate
: is where you select the baud rate
the receiver will use to communicate with the
radio.
Parity
: When selectable, is where you select
the parity the receiver will use to
communicate with the radio.
Serial Port (GPS Receiver)
: is where you
select the serial port the receiver will use to
communicate with the radio.
: automatically sets all the selectable values to their
defaults based on the selected hardware.
: sets the selected radio communication settings in the
receiver.
Note: The radio communication settings are also set in the receiver
during the base and rover setup procedure. Therefore, you will not
usually have to use the Receiver Set button on this page.
Comentarios a estos manuales