Spectra-precision Survey Pro v4.6 Recon and Nomad User Manual Manual de usuario descargar pdf (Pagina 175)

Other Tutorials

165

GeoLock

GeoLock is a feature that uses a GPS receiver to calculate your

position so while working robotically, if the total station loses lock of

the prism, it can quickly turn to the location of the prism based on the

GPS position and then automatically perform a search to lock back

onto the prism.

GeoLock is available when using a Trimble or Geodimeter robotic

total station, along with a GPS receiver that outputs a NMEA signal.

Most inexpensive consumer handheld GPS receivers will output the

required signal.

Communication between the data collector and GPS receiver can take

place using a compatible data cable, Bluetooth, or a direct connection

such as with a CompactFlash GPS receiver.

All of the GeoLock features and settings are accessed

while in the Remote Control

or Remote Shot screens.

Specifically, you will use the GeoLock button and the

satellite icon in the Command Bar, which changes

color to indicate different situations related to GeoLock,

as described below.

If you tap on the satellite icon

, a list will open to

access other GeoLock-related screens. At the bottom of

this list is a message indicating the current GPS status,

which coincides with the color of the satellite icon as

follows:

(gray icon) Off: GeoLock is not enabled.

(yellow icon) On - Collecting Data: GeoLock is active

but a localization solution does not yet exist.

(red icon) No GPS Data or GeoLock requires Backsight set: No

NMEA data is available or the backsight has not yet been set.

(green icon) On - Ready: GeoLock is active and a localization

solution exists.

1 2 ... 170 171 172 173 174 175 176 177 178 179 180 ... 366 367

Sin comentarios

Spectra-precision Survey Pro v4.6 Recon and Nomad User Manual Manual de usuario Pagina 175