Spectra-precision Survey Pro v3.80 Recon GPS User Manual Manual de usuario descargar pdf (Pagina 36)

GPS User’s Manual

RTK rover, tap . This will

automatically set the switch to

Auto Connect RTK with saved

configuration

. When you tap or from the RTK

Survey menu, the correct COM port and settings will be set

automatically.

Base Station Receiver Setup

Use the Base Setup screen to configure a GPS receiver to be an RTK

base station and to set the base reference position in Survey Pro.

Tap on the Survey

menu to open the Current GPS

Base screen where information about the current setup is

displayed. Tap … to start the Base Setup

wizard.

Pick the Base Point

Tap to select your antenna type and measure the slant

or vertical height of the antenna.

Note: If this receiver has already set an antenna with Survey Pro,

the measurement and settings will be recalled from the registry, so

you will not have to do this step again.

Enter a name for the

Base Point

. You can select an existing point

from the job or you can enter a new point name for the job. If you

select:

•

An existing point with geodetic coordinates, we send these

reference coordinates to the GPS receiver and configure the

base coordinate in Survey Pro.

•

An existing point with plane only (N,E,Elev) coordinates, we

calculate geodetic coordinates from the current projection,

then send this reference position to the GPS receiver and

configure the base coordinate in Survey Pro.

1 2 ... 31 32 33 34 35 36 37 38 39 40 41 ... 94 95

Sin comentarios

Spectra-precision Survey Pro v3.80 Recon GPS User Manual Manual de usuario Pagina 36