Spectra-precision Survey Pro v3.80 Recon GPS User Manual Manual de usuario Pagina 30

  • Descarga
  • Añadir a mis manuales
  • Imprimir
  • Pagina
    / 95
  • Tabla de contenidos
  • MARCADORES
  • Valorado. / 5. Basado en revisión del cliente
Vista de pagina 29
GPS User’s Manual
26
North\East Grid
. Select this choice to have coordinates
increase positive in the north and east directions.
South\West Grid
. Select this choice to have coordinates
increase positive in the south and west directions.
Note: The geodetic calculation engine and the Survey Pro coordinate
geometry engine are separate components. While the geodetic engine
can properly handle southwest grid systems, Survey Pro can only
operate on a northeast grid system. However, since a southwest grid
with a south azimuth is a mirror image of a northeast grid with a
north azimuth, Survey Pro can handle this configuration with the
following work around: You must set the
Azimuth Type
to North
Azimuth
on the Units
card of the Job, Settings screen. You then treat
north as south and east as west, and the coordinates will be correct
for a southwest grid and south azimuth zone.
7.
Tap to enter the zone parameters for the new map
projection.
8.
Key in the five or six parameters for your new map projection
zone.
9.
If your zone is Oblique Mercator Angle, the next screen is used to
pick the
Origin
and
Azimuth
values.
10.
Tap to select the datum. The screen that opens will depend
on the datum type you specified on the first screen.
11.
If you selected
Pick from Data Base
, pick the database
Datum
from
the list. If you selected either
Custom Molodensky
or
Custom
Similarity
, then select an ellipse for the new datum. You can select
Ellipse from Data Base
to use an ellipsoid record from the
database, or you can select
Key In Ellipse
to input parameters for
a custom ellipse.
12.
Tap to open the next screen. If you are using a database
datum, the next screen displays the parameters for the new map
projection zone and you can the record.
13.
If you are using a custom datum, enter the datum translations
from WGS84 to Local.
Vista de pagina 29
1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 94 95

Comentarios a estos manuales

Sin comentarios