Spectra-precision Survey Pro 3.80 Recon GPS Reference Manual Manual de usuario Pagina 30
- Pagina / 99
- Tabla de contenidos
- MARCADORES
Valorado. / 5. Basado en revisión del cliente
GPS Reference Manual
30
Note: If your antenna type is Manual, the Radius and Notch fields
will not be available
: Updates the base antenna settings with the values selected on
this screen.
Note: When this screen is used by the RTK rover for updates of
antenna height during a survey, the Set button will send the new
antenna parameters to the receiver as well as updating Survey Pro's
settings.
Rover Setup
The Rover Setup screen is used to configure an RTK rover to begin
receiving differential corrections and to start the survey with the base
reference position.
Rover Status
: displays the status of the rover.
Base set at
: displays the current base point. This will be
empty if the base is not set.
•
Lat
: displays the latitude of the base.
•
Long
: displays the longitude of the base.
•
Height
: displays the ellipsoid height of the base.
: is used when the GPS base position is
not known to this data collector. This function will get
the base station’s geodetic coordinate over the radio link
and set the base position in Survey Pro. It will then
configure the rover receiver to start receiving differential
corrections.
: is used when the base station was set with
- SURVEY PRO 1
- Table of Contents 3
- Job Menu 5
- Settings 6
- Measure Mode Settings 8
- Projection Settings 10
- Post Process Settings 11
- Receiver Settings 12
- Base Modem Settings 14
- Radio Communications Screen 15
- Radio Settings Screen 15
- Rover Modem Settings 17
- General Settings 17
- RTK Configurations 18
- Survey Menu – RTK 19
- GPS Status 20
- Data Link 22
- Sky View 22
- Sat Info 23
- Position 24
- Base Setup 25
- Base Setup Two – SET 27
- Base Setup Two – GET and SET 28
- Base Receiver Antenna 29
- Rover Setup 30
- Rover Receiver Antenna 31
- Control Points 32
- Manual Entry GPS 33
- Check Control Point Screen 33
- Occupy Control Point Screen 35
- Data Collection 36
- Feature Collection Screen 37
- Offset Shots 38
- Occupy Data Points Screen 39
- Projection Screen 40
- Mapping Plane 41
- Projection Key In Setup 43
- Ground - TDS Localization 48
- Solve Localization 50
- Horizontal Card 53
- Vertical Card 53
- Localization Calculator 54
- Solve Localization – Results 57
- Geoid Model Setup 60
- Ellipsoid Height 61
- Remote Elevation 62
- Receiver Recording 64
- Receiver Information 65
- Readjust Points 66
- Projection Calculator 68
- Survey Menu – Post 71
- Processing 71
- Start Static Rx 73
- Start Stop/Go Rx 75
- Stakeout Menu 79
- Stake Points 80
- Stake to Line 82
- Stake to Line – Screen Two 83
- distance from the line 84
- Slope Staking 85
- Slope Staking – Screen Four 86
- Line and Offset 88
- Curve and Offset 89
- Spiral and Offset 89
- Show Station and Offset 90
- Store Offset Points 91
- Stake DTM 92
- Where is Next Point 94
- Inverse Menu 95
- Cogo Menu 95
- Curve Menu 95
- Adjust Menu 95
- Transfer Menu 95
Relacionado con productos y manuales para Software Spectra-precision Survey Pro 3.80 Recon GPS Reference Manual
(178 paginas)König Pouzdra na tablety uživatelské příručky
Začínající na C
Comentarios a estos manuales