Spectra-precision Survey Pro v4.5 Ranger User Manual Manual de usuario descargar pdf (Pagina 325)

Basic GPS Module

315

the base but the projection is not fully set and solved for this

survey. The button will say Finish if you have set the base

and the projection is solved.

a. On Next >:

i. If the base was not set with this wizard, takes

you to Setup Remote Base

screen (Page 316).

ii. If the base was set with this wizard, writes

the base and rover setup raw data, and takes

you to Solve Projection

routine (Page 317).

b. On Finish: Writes the base and rover setup raw data,

sets the rover receiver and exits.

Start Survey – Connect to Rover

(Remote Base or Internet Base)

There are two workflows when you start a survey connecting to the

rover:

• The base broadcasting on a radio is already set and you wish

to start the rover with the remote base. This is the case

where there is more than one rover on a job site, or when you

exit and restart a job and you wish to restart the survey

without traveling back to the base.

• You are using the Internet to get corrections.

The workflow below is described for the NTRIP case. The remote

base on a radio is similar to the Set Rover and Setup Remote Base

procedure described above.

Connect to Internet

When Internet RTK is selected in the Job > Settings > Radio Settings

screen, we will always attempt to connect to the rover on the start of

the Start Survey Wizard. After connecting to the rover, we will dial

the Internet and attempt to decode the network type.

After the network type has been decoded, if it is a single base network

without an NTRIP logon protocol, we will go straight to Rover setup,

if it is a NTRIP network, we will go to the NTRIP Services page.

1 2 ... 320 321 322 323 324 325 326 327 328 329 330 ... 338 339

Sin comentarios

Spectra-precision Survey Pro v4.5 Ranger User Manual Manual de usuario Pagina 325