Spectra-precision Survey Pro v5.3 Manual de usuario descargar pdf (Pagina 20)

Job Settings The settings and values entered for a new job become the default values for any

subsequent new jobs. A short description of the jobs settings is given below.

• Units [1]: When creating a new job, set all the desired units for the job. You can

also enable the setting for Earth Curvature and Refraction correction for optical

measurements.

• Control File [2]: Control points can optionally be imported from another existing

job by checking the Use a Control File check box. After tapping Finish to create the

job, a message will indicate the number of imported points. If you are using a

control file, by default the coordinate system of this control file will be used for the

new job. You can override this default setting on the coordinate system page. A

control file can be imported from either a .Job or .Survey file.

[1] [2]

[3] [4]

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 105 106

Sin comentarios

Spectra-precision Survey Pro v5.3 Manual de usuario Pagina 20